Over time most PCB designs need to change – a mistake is found, or a part becomes obsolete, etc. Typically once the changes are complete, a new set of manufacturing files (Gerbers, NC Drill files,...
I'll give you the answer, before I explain: Join Interactive Probably the most frustrating experience for anyone who has attempted to convert a DXF file to Gerber, is the dreaded "boundaries are open in the Gerber...
Today we're happy to announce the new releases for our Linux 64-bit users. ACE 3000, FAB 3000, and DFM Now!, are ready for download. Note: Our Linux 64-bit software tools are on average 25% faster than on Windows,...
The IPC-2581 open standard is a XML-based single file format that incorporates a wide range of board fabrication data including layer stackup details, complete physical layouts, routing, component and BOM information. The open standard is maintained by the IPC-2581 Consortium....
By Simon Garrison, Numerical Innovations WARNING: Your Gerber Files may contain hundreds of hidden mistakes! What are Gerber files? For the past 30 years, Gerber has been the de-facto standard file format used to manufacture...
For electronic designers worldwide, the need for increased signal speed within smaller layout areas is an everyday struggle. Not only is manufacturing being pushed to the limits with minute geometries packed into dense regions, but...